Avaya S8300 Manual page 49

Task
7. If IA770 is installed, get
IA770 data and stop
IA770.
Page 225.
8. Record configuration
information.
Page 232.
9. Restore default server
configuration settings
10. Set time, date, and time
zone.
Page 259.
11. Install post-conversion
service pack file, if any.
Page 260.
12. Install the LSP license file.
Starting on page 263.
13. Install the authentication
file.
Starting on page 264.
14. Configure server.
Starting on page 464,
ending on page 478.
15. Reboot the LSP.
Steps/Comments
On the ICC/LSP
If you have not already done so, in the Record
Configuration Information task, record all of the
configuration information, regardless of the fact that you
are not upgrading Communication Manager.
You will re-enter some of this information after the
conversion.
On the Maintenance Web Interface, click Restore
Defaults under Server Configuration.
The time of the LSP must be set to the same time zone as
its primary controller, even if the LSP is physically located
in a different time zone.
Skip the Verify Media Server Configuration section
starting on page 247.
Fill in each Configure Server screen with data for
the LSP. Some of the configuration data will be the
same as that for the ICC.
On the Configure Local Survivable Processor
screen, select one of the three LSP choices
depending on the primary controller type.
Open a SAT session and enter reset system
4.
After the reboot, the LSP should be registered with
the primary controller and in a few minutes
translations should be synchronized.
Issue 2 June 2005 49