Avaya S8300 Manual page 20

Converting an S8300 from LSP to ICC and upgrading Communication Manager from 1.x to 2.x
At the customer site
Perform the tasks in this section at the customer site.
Go to the standard documentation
Use Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300
Media Server, 555-234-100, Issue 8, April 2005.
To convert the LSP to an ICC, you complete selected tasks from Chapters 3 and 5.
You need to complete only some of the tasks in these chapters. The specific tasks
are identified by page number in the left-hand column. The subtasks to perform or
skip are listed in the right-hand column.
It is important to note where the task is performed. Most of the tasks are done on a
server or gateway — on the LSP/ICC S8300, on the primary controller for the LSP,
on a DHCP server, or on the gateway processor (MGP). The headings below
indicate on which of these devices the task is performed.
Note:
Note:
1. Administer the primary
controller to which the
LSP was formerly
assigned.
Start on page 157 if
the primary controller
was an S8300.
Start on page 163 if
the primary controller
was an S8700 or
S8500.
2. Administer the media
gateway.
Starting on page 170.
20 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
Task
If additional LSPs are to be assigned to the converted ICC, they
must be upgraded first; then the conversion and upgrade of the new
ICC can proceed.
On the LSP's primary controller
Steps/Comments
Remove LSP node name.
Dis-associate LSP from network region.
Remove LSP from the LSP screen.
Repeat for each additional LSP to be
controlled by the new ICC.
Remove media gateway.
Repeat for each additional gateway to be
controlled by the new ICC.
Skip the subtasks, Verify Changes and Save
Translations in this section.