Avaya S8300 Manual page 63

Task
12. Administer the primary
controller that the G700
LSP will use.
Start on page 157 if the
primary controller is an
S8300.
Start on page 163 if the
primary controller is an
S8700 or S8500.
13. Administer the G700
media gateway.
Starting on page 170.
14. Reassign endpoints to the
new S8300/G700.
For information on updating
translations, see the
Administrator Guide for Avaya
Communication Manager,
03-300509.
15. Update the alternate
controller list on the
DHCP server.
See page 175.
Assign node names.
Administer network regions, including the IP
network map.
Associate G700 LSP with a network region.
Administer LSP screen for the G700 LSP.
Configure IP network map.
Add media gateway
Add station and trunk translations for the G700.
For this scenario, the gateway will not automatically
register with the primary controller at this point. Skip the
subtasks Verify Changes and Save Translations in this
section.
When the gateway finally registers, the media modules
will automatically populate.
Update translations — add stations and trunks
- Use the Avaya Installation Wizard and the
Electronic Pre-Installation Worksheet (EPW).
- Alternatively, use SAT commands.
Place test calls to verify.
Reassign IA770 users to the messaging system
used by this primary controller. Enter test
messages to verify.
Update the alternate controllers list for all endpoints
(and gateways using this LSP for failover) to reflect
the LSP on the new G700.
On the DHCP server
Steps/Comments
Issue 2 June 2005 63