Avaya S8300 Manual page 53

At the customer site
Perform the tasks in this section at the customer site.
Go to the standard documentation
Use Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300
Media Server, 555-234-100, Issue 8, April 2005.
To convert the LSP to an ICC, you complete selected tasks from Chapters 3 and 5.
You need to complete only some of the tasks in these chapters. The specific tasks
are identified by page number in the left-hand column. The subtasks to perform or
skip are listed in the right-hand column.
It is important to note where the task is performed. Most of the tasks are done on a
server or gateway — on the LSP/ICC S8300, on the primary controller for the LSP,
on a DHCP server, or on the gateway processor (MGP). The headings below
indicate on which of these devices the task is performed.
1. Administer the primary
controller to which the
LSP was formerly
assigned.
Start on page 157 if
the primary controller
was an S8300.
Start on page 163 if
the primary controller
was an S8700 or
S8500.
2. Administer the media
gateway.
Starting on page 170.
3. Update the alternate
controller list on the
DHCP server.
See page 175.
Task
On the LSP's primary controller
On the DHCP server
Steps/Comments
Remove LSP node name.
Dis-associate LSP from network regions.
Remove LSP from the LSP screen.
Repeat for every LSP to be controlled by
the new ICC.
Remove media gateway.
Repeat for each gateway to be controlled
by the converted LSP.
Skip the subtasks, Verify Changes and Save
Translations in this section.
Issue 2 June 2005 53