Avaya S8300 Manual page 54

Converting an S8300 from LSP to ICC (Communication Manager 2.1 or later)
4. Telnet to the MGP and
change the gateway's
controller list.
Start on page 487.
5. Backup all system files
— translations, OS,
and security backup
sets.
Start on page 229.
6. Record configuration
information.
Page 232.
7. Restore default server
configuration settings
8. If running CM version
2.2 or earlier, and
using IA770, install the
CWY1 board on to the
S8300B.
54 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
Task
On the gateway's MGP
On the LSP to be converted
Steps/Comments
Clear the gateway's controller list.
Enter the IP addresses of the new ICC and
up to three alternate controllers.
If the media gateway is a G350, enter:
copy running-config
startup-config
Reset MGP.
These backup sets will not be restored on the
S8300B. They should be backed up in case it is
necessary to revert to the original configuration.
If you have not already done so, in the Record
Configuration Information task, record all of the
configuration information, regardless of the fact
that you are not upgrading Communication
Manager.
You will re-enter some of this information after the
conversion.
On the Maintenance Web Interface, click
Restore Defaults under Server Configuration.
Shut down the S8300B.
Remove the S8300B from the gateway. (If
the gateway is a G700, the LED panel
must be removed together with the s8300.)
Install the CWY1 board on to the S8300B.
Re-insert the S8300B (together with the
LED panel if the gateway is a G700) into
the gateway.
Install IA770 and administer CWY1
integration according to Avaya IA770
INTUITY AUDIX Messaging Application,
Release 3.0, Installation, Upgrades, and
Troubleshooting (11-300532).