Avaya S8300 Manual page 65

Task
24. Verify LSP translations
date and time.
25. Verify LSP status.
26. If the LSP's translations
have not synchronized
with the primary
controller, invoke
translation
synchronization.
27. Implement any additional
design changes to voice
and/or voice messaging
networks.
28. Verify that the S8300B is
an LSP associated with
the new G700 gateway.
To view the LSP's translations date and time, enter
list configuration software.
On the primary controller
At the SAT prompt, enter display lsp. The LSP
name and IP address should be listed. The
Service State? field should be in-service/
idle.
The Translations Updated should match the
translations date and time on the primary
controller. To view the primary controller's
translations date and time, enter list
configuration software.
On the primary controller, enter the Linux
command filesync -a ipaddress
where ipaddress is the IP address of the LSP.
Ensure that the translation synchronization
completed successfully. Wait several minutes, then
check the timestamp of the LSP translation files
using the SAT command display lsp on the
primary controller.
Post-conversion tasks
The S8300B should already be registered as an LSP, but
verify its association with the new G700.
Steps/Comments
Issue 2 June 2005 65