Avaya S8300 Manual page 41

Task
16. Administer the media
gateway.
Starting on page 170.
17. If upgrading to CM
versions later than
CM2.2, and using
IA770, administer the
S8300B for H.323
integrated messaging.
18. Reassign endpoints
from the former
primary controller to
the standalone ICC.
For information on
updating translations, see
the Administrator Guide for
Avaya Communication
Manager, 03-300509.
19. Reboot the ICC.
20. Verify that the media
gateway has
registered with the
ICC.
Steps/Comments
Add media gateway.
Repeat for each gateway to be controlled
by the new ICC.
For this scenario, the gateway will not
automatically register with the ICC at this point.
Skip the subtasks, Verify Changes and Save
Translations in this section.
When the gateway finally registers, the media
modules will automatically populate, unless you
are doing administration without hardware
(AWOH). In this case, you will have to enter the
media module types for each slot.
See Avaya IA770 INTUITY AUDIX Messaging,
Release 2.0, Installation, Upgrades, and
Troubleshooting (11-300399).
Update translations — add stations and
trunks
- Using the Avaya Installation Wizard and
the Electronic Pre-Installation Worksheet
(EPW) is recommended.
- Alternatively, use SAT commands.
Place test calls to verify.
Reassign messaging system endpoints of
the former primary controller to the
messaging system used by the new ICC.
Enter test messages to verify.
Open a SAT session and enter reset system
4.
After the reboot, any LSPs associated with the
new ICC should be registered with the ICC, and
in a few minutes translations should be
synchronized.
Open a SAT session and enter list
media-gateway. Verify that the
Registered field (Reg?) is set to y.
Place a test call.
Issue 2 June 2005 41