Avaya S8300 Manual page 27

Converting media server between icc and lsp modes

Hide thumbs Also See for S8300:

Chapter 3: Converting an S8300 from ICC to LSP

This chapter provides a high-level list of tasks for converting an S8300 primary controller to LSP

mode and upgrading Communication Manager from 2.0.x to 2.x

Note:

An upgrade to Communication Manager 2.1 or later requires an S8300B Media

Note:

Server, and means replacing the S8300A Media Server, if it is in use.

To complete these tasks, you will need the following additional documents:

Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media

Server, 555-234-100. To obtain this document, go to

navigate to Installations, Migrations, Upgrades & Configurations; then select the

appropriate document.

Administrator Guide for Avaya Communication Manager, 03-300509.

Converting between an ICC and

documents for non-US systems should be available from the regional web sites.

For this scenario, it is possible that an S8300A configured as an ICC and running

Communication Manager release 2.0.x may have to be replaced by an S8300B running

Communication Manager release 2.x in LSP mode.

The tasks include:

1. Moving the endpoints supported by the ICC to a different primary controller.

2. Updating the DHCP server alternate controller list.

3. Updating the gateway MGC list.

4. Replacing the S8300A Media Server with the S8300B Media Server, if necessary.

5. Remastering the S8300B hard drive.

6. Installing 2.x Communication Manager software.

7. Configuring the S8300B as an LSP.

8. Upgrading the gateway and media module firmware.

Note:

Although a new license is not required when upgrading from 2.0.x to 2.x,

Note:

conversion from an ICC to an LSP does require a new license.

and upgrading Communication Manager from

2.0.x to 2.x

http://support.avaya.com

LSP, which is for U.S.-based systems only. Similar

and

Issue 2 June 2005