Avaya S8300 Manual page 37

4. Obtain a replacement
S8300B Media Server,
if needed.
5. Obtain the
Communication
Manager 2.x software
CD and a USB
CD-ROM drive.
At the customer site
Perform the tasks in this section at the customer site.
Go to the standard documentation
Use Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300
Media Server, 555-234-100, Issue 8, April 2005.
To convert the LSP to an ICC, you complete selected tasks from Chapters 3 and 5.
You need to complete only some of the tasks in these chapters. The specific tasks
are identified by page number in the left-hand column. The subtasks to perform or
skip are listed in the right-hand column.
It is important to note where the task is performed. Most of the tasks are done on a
server or gateway — on the LSP/ICC S8300, on the primary controller for the LSP,
on a DHCP server, or on the gateway processor (MGP). The headings below
indicate on which of these devices the task is performed.
Note:
Note:
Task
Task
If additional LSPs are to be assigned to the converted ICC, they
must be upgraded first; then the conversion and upgrade of the new
ICC can proceed.
Steps/Comments
In this scenario, Communication Manager will
be upgraded to version 2.1 or later, which only
runs on the S8300B Media Server. The software
to remaster the hard drive is already loaded on
the S8300B hard drive.
If you have a TFTP server configured on
your services laptop, you can read the
Server CD and transfer the software to the
S8300B Media Server from your laptop.
Alternatively, the steps to remaster the
S8300 hard drive and install the 2.x
release of Communication Manager
software can be read from an external
USB CD-ROM drive.
Steps/Comments
Issue 2 June 2005 37