Avaya S8300 Manual page 29

Task
4. Obtain a replacement
S8300B Media Server,
if needed.
5. Obtain the
Communication
Manager 2.x software
CD and a USB
CD-ROM drive.
At the customer site
Perform the tasks in this section at the customer site.
Go to the standard documentation
Use Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media
Server, 555-234-100, Issue 8, April 2005.
To convert the ICC to an LSP, you complete selected tasks from Chapters 3 and 5. You need to
complete only some of the tasks in these chapters. The specific tasks are identified by page
number in the left-hand column. The subtasks to perform or skip are listed in the right-hand
column.
It is important to note where the task is performed. Most of the tasks are done on a server or
gateway — on the ICC/LSP S8300, on the primary controller for the LSP, on a DHCP server, or
on the gateway processor (MGP). The headings in the table indicate on which of these devices
the task is performed.
Task
In this scenario, Communication Manager will be upgraded
to version 2.1 or later, which only runs on the S8300B
Media Server. The software to remaster the hard drive is
already loaded on the S8300B hard drive.
If you have a TFTP server configured on your
services laptop, you can read the Server CD and
transfer the software to the S8300B Media Server
from your laptop.
Alternatively, the steps to remaster the S8300 hard
drive and install the 2.x release of Communication
Manager software can be read from an external USB
CD-ROM drive.
Steps/Comments
Steps/Comments
Issue 2 June 2005 29