Avaya S8300 Manual page 38

Converting an S8300 from LSP to ICC and upgrading Communication Manager from 2.0.x to 2.x
1. Administer the primary
controller to which the
LSP was formerly
assigned.
Start on page 157 if
the primary controller
was an S8300.
Start on page 163 if
the primary controller
was an S8700 or
S8500.
2. Administer the media
gateway.
Starting on page 170.
3. Update the alternate
controller list on the
DHCP server.
See page 175.
4. Telnet to the MGP and
change the gateway's
controller list.
Start on page 487.
38 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
Task
On the LSP's primary controller
On the DHCP server
Steps/Comments
Remove LSP node name.
Dis-associate LSP from network regions.
Remove LSP from the LSP screen.
Repeat for each additional LSP to be
controlled by the new ICC.
Remove media gateway.
Repeat for each additional gateway to be
controlled by the converted LSP.
Skip the subtasks, Verify Changes and Save
Translations in this section.
On the gateway
Clear the gateway's controller list.
Enter the IP addresses of the new ICC and
up to three alternate controllers.
If the media gateway is a G350, enter:
copy running-config
startup-config
Reset MGP.