Avaya S8300 Manual page 12

Converting an S8300 from ICC to LSP and upgrading Communication Manager from 1.x to 2.x
3. Reassign endpoints
from the ICC to this
primary controller.
For information on
updating translations, see
the Administrator Guide for
Avaya Communication
Manager, 03-300509.
4. Update the alternate
controller list on the
DHCP server.
See page 175.
5. Telnet to the MGP and
change the gateway's
controller list.
Start on page 487.
6. Verify that the media
gateway has
registered with the
primary controller.
12 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
Task
On the DHCP server
On the LSP's primary controller
Steps/Comments
Update translations — add stations and
trunks.
If the primary controller is a new installation,
using the Avaya Installation Wizard and the
Electronic Pre-Installation Worksheet
(EPW) is recommended.
Alternatively, use SAT commands.
Place test calls to verify.
Reassign IA770 endpoints to the
messaging system used by this primary
controller. Enter test messages to verify.
On the gateway
Clear the gateway's controller list.
Enter the IP addresses of the primary
controller and up to three alternate
controllers.
Set the LSP transition points.
If the media gateway is a G350, enter:
copy running-config
startup-config
Reset MGP
Open a SAT session and enter list
media-gateway. Verify that the
Registered field (Reg?) is set to y.
Place a test call.