Avaya S8300 Manual page 62

Migrating a G350 LSP to a G700 LSP (Communication Manager 2.1 or later)
6. Insert the S8300B into the
G700.
Page 90.
7. Insert media modules, as
necessary.
Page 92.
8. Insert additional modules,
if necessary.
Page 95.
9. Complete the hardware
installation.
Page 97.
10. Administer the primary
controller to which the
G350 LSP was formerly
assigned.
Start on page 157 if the
primary controller was an
S8300.
Start on page 163 if the
primary controller was an
S8700 or S8500.
11. Administer the G350
media gateway.
Starting on page 170.
62 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
Task
On the primary controller
Steps/Comments
!
CAUTION:
In the G700, it is necessary to remove the
CAUTION:
LED Panel, and insert the S8300B and
the LED Panel into the G700
simultaneously.
Note: The MM430 and MM342 Media Modules are
compatible with the G350, but are not compatible with
the G700.
Insert an Expansion Module
Insert an Avaya X330STK Stacking Module
Cable multiple units.
Attach ground connectors.
Connect AC power.
Check and connect DC power.
Remove G350 LSP node name.
Dis-associate G350 LSP from network region.
Remove G350 LSP from the LSP screen.
Remove G350 media gateway.
Remove the media module types for each slot.
Remove station and trunk translations for the
G350.
Skip the subtasks, Verify Changes and Save Translations
in this section.