Mitsubishi Electric MELSERVO-J4 Series Transition Handbook page 445

Part 7: Common Reference Material
MR-J3-_T_
No. Name
Input signal device selection 3
PD07
(CN6-3)
Input signal device selection 4
PD08
(CN6-4)
Output signal device selection 1
PD09
(CN6-14)
Output signal device selection 3
PD11
(CN6-16)
PD16 Input polarity selection
PD19 Input filter setting
PD20 Function selection D-1
PD22 Function selection D-3
PD24 Function selection D-5
MR-J3-D01 input signal device
Po02
selection 1 (CN10-21，26)
MR-J4-_A_-RJ
Type Target No.
Hex _ _ XX PD18
Hex _ _ XX PD20
Hex _ _ XX PD28
Hex _ _ XX PD24
Hex _ _ _ X PT29
Hex _ _ _ X PD29
_ _ _ X
Hex _ _ X _ PD30
_ X _ _
Hex _ _ _ X PD32
Hex _ _ X _ PD34
_ _ XX
Hex Po02
XX _ _
7 - 68
Type Target
The setting value will be converted as
shown in table 7.1.
If the setting value is not listed in table
7.1, the value will be converted to 0A
_ _. (LSP)
When conversion of the input/output
Hex XX _ _
signal assignment is enabled, the
conversion will be performed
according to the control signal
connection of the renewal tool.
If the conversion is not enabled, the
setting value will be initialized.
The setting value will be converted as
shown in table 7.1.
If the setting value is not listed in table
7.1, the value will be converted to 0B
_ _. (LSN)
When conversion of the input/output
Hex XX _ _
signal assignment is enabled, the
conversion will be performed
according to the control signal
connection of the renewal tool.
If the conversion is not enabled, the
setting value will be initialized.
The setting value will be converted as
shown in table 7.2.
If the setting value is not listed in table
7.2, the value will be converted to _ _
02. (RD)
When conversion of the input/output
Hex _ _ XX
signal assignment is enabled, the
conversion will be performed
according to the control signal
connection of the renewal tool.
If the conversion is not enabled, the
setting value will be initialized.
The setting value will be converted as
shown in table 7.2.
If the setting value is not listed in table
7.2, the value will be converted to _ _
24. (ZP)
When conversion of the input/output
Hex _ _ XX
signal assignment is enabled, the
conversion will be performed
according to the control signal
connection of the renewal tool.
If the conversion is not enabled, the
setting value will be initialized.
Hex _ _ _ X The setting value will be maintained.
Hex _ _ _ X The setting value will be maintained.
_ _ _ X The setting value will be maintained.
Hex _ _ X _ The setting value will be maintained.
_ X _ _ The setting value will be maintained.
_ _ _ 0 will be changed to _ _ _ 2.
Hex _ _ _ X
_ _ _ 1 will be changed to _ _ _ 0.
_ _ _ 2 will be changed to _ _ _ 1.
Hex _ _ X _ The setting value will be maintained.
The setting value will be maintained.
_ _ XX
The setting value will be maintained
regardless of whether conversion of
Hex
the input/output signal assignment
XX _ _
(parameter converter function) is
enabled or disabled.
Conversion rule