Siemens SINAMICS Series Operating Instructions Manual page 285

8.4.1.2 Full drive commissioning
Adjust the rated device currents
Note
The US rating must be set at p50067 for Base Drives (type 6RA80xx-2xxxx) manufactured in
North America.
The rated armature DC current for the device must be adjusted by setting p50076[0] (in %)
or p50067 if:
Maximum armature current < 0.5 × rated armature DC current for the device
The rated field DC current for the device must be adapted by setting p50076[1] (in %) if:
Maximum field current < 0.5 × rated field DC current for the device
Adapt to the actual device supply voltage
p50078[0]
p50078[1]
Acquiring the motor data
The motor data can be taken from the motor rating plate.
Figure 8-4
SINAMICS DCM DC Converter
Operating Instructions, 12/2018, A5E34763375A
Rated input voltage for converter armature (in volts)
Rated input voltage for converter field (in volts)
Example of a rating plate
8.4 Commissioning using the AOP30 operator panel
Commissioning
283