Siemens SINAMICS Series Operating Instructions Manual page 488

Hide thumbs Also See for SINAMICS Series:

Table of Contents

Descriptions of functions

10.5 Communication via PROFINET IO

Setting the IP address in Windows 7

The following procedure is based on the Windows 7 operating system. Under other operating

systems (such as Windows XP), operation may differ slightly.

1. In the PG/PC call the control panel using the "Start > Control Panel" menu item.

2. In the control panel of your PG/PC, under "Network and Internet", select the "Network and

Sharing Center" function.

3. For your network card that is displayed, click the connection link.

4. Click in the status dialog of the connection on "Properties" and acknowledge the

subsequent confirmation prompt with "Yes".

5. In the properties dialog of the connection, select the "Internet protocol 4 (TCP/IPv4)"

element and then click "Properties".

6. In the properties dialog, activate the "Use the following IP address" option.

7. Set the IP address of the PG/PC access interface to the Control Unit to 169.254.11.1 and

the subnet mask to 255.255.0.0.

Figure 10-33 Example: IPv4 address of the PG/PC

8. Click "OK" and close the Windows-specific window of the network connections.

SINAMICS DCM DC Converter

Operating Instructions, 12/2018, A5E34763375A