Signals; Resetting Fault Message - Bosch FPA‑5000 User Manual

48 en | Fault message
–
–
–
–
Select OK to return to the list of all fault messages. Reset, see Resetting fault message, page
48 .
Block, see Blocking an element, page 49 . Select Details (if available) to go directly to the
respective Diagnostics window for troubleshooting, see Diagnostics, page 56 .
10.2.8

Signals

Optical signals
The
Depending on the type of fault, an additional yellow signal light lights up (see also Status
LEDs, page 14 ):
–
–
–
–
–
–
Acoustic signal
An internal signal tone sounds on the system.
To temporarily silence the internal buzzer:
Press
10.3

Resetting fault message

Caution!
If a message does not have to be reset, it is removed from the display as soon as the fault has
!
been rectified.
Depending on the configuration, three different variants are offered for resetting; see
Resetting alarm message, page 43 .
There are two ways to reset a fault message:
–
–
If a list field is marked with an "R", the process of resetting is not yet complete for this
element.
TEXT
If an element cannot be reset, it will continue to be displayed in the list.
After the successful resetting of all elements, the standby display is displayed.
2020-07 | 3.0 | F.01U.378.877
Date and time of the message
Physical and logical addressing of the element
Only for LSN detectors: specification of the detector type
Action text (depending on the configuration)
"fault" icon lights up yellow.
Fault system (LED steady)
Fault power (LED steady)
Fault detector (LED blinking)
Fault transmission device (LED blinking)
Fault signals (LED blinking)
Output to fire protection equipment fault (LED blinking)
.
Select Reset in the message display or
Select the fault message and then press Reset in the detailed view
The selected element/element group is reset.
R
User Guide
FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
Bosch Sicherheitssysteme GmbH