Displaying Individual Elements Of An Element Group; Information About Individual Elements; Displaying Additional Information - Bosch FPA‑5000 User Manual

FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
Notice!
15–30 seconds after the last entry (e.g. after scrolling through the list), the first and oldest
fault message is displayed at the beginning of the list again.
10.2.5

Displaying individual elements of an element group

To display the individual elements in an element group, select the element group you require.
The fault messages of the individual elements are listed.
10.2.6

Information about individual elements

The trouble message contains information about:
–
–
–
–
–
Example:
Fault
#002
Element category:
Message type:
Element address
Message number
Installation location of the
element
Notice!
Depending on the configuration of the system, either the logical or physical address of the
element is displayed.
10.2.7

Displaying additional information

To display further information about the individual elements, select the fault message you
require.
Notice!
The information displayed is entered in the FSP-5000-RPS programming software.
The following information is displayed:
–
–
Bosch Sicherheitssysteme GmbH
Element category
Message type
Element address
Message number
Additional information (e.g. the installation location)
Transmission device
Cafeteria
Element category
Message type
00026-
Transmission device
Fault
The following transmission device has caused a fault:
00026 - 004: The fourth transmission device (004) in the 26th
group (00026).
The fault messages are numbered chronologically.
The message number in the second line indicates the sequence
in which the fault messages were received.
002: The second fault message to be received.
Cafeteria
User Guide
Fault message | en
004
2020-07 | 3.0 | F.01U.378.877
47