Consistency Check; Ethernet Ports - Bosch FPA‑5000 User Manual

FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
3.
All networked nodes that can be reached via the node currently being operated and that are
recognized within the system network are displayed under Node.
CAN1 to USB1 designate the interfaces on the currently operated panel node. In this example,
it is the node 1 interfaces.
The type of interface on the panel node currently being operated is listed under interface.
The following interfaces can be designated:
–
–
–
–
–
–
–
The number of nodes that need to be passed in order to reach the listed node is entered
under distance. For nodes that are directly reachable via IP multicast, the value is 1; for nodes
that are connected via other interfaces (e.g. CAN) to nodes reachable via IP multicast, the
value is increased in increments accordingly (e.g. connected via IP multicast + CAN1/CAN2,
value = 2).
A physical node number from 1 to 64 can be assigned to panels.
13.7.2

Consistency check

Inconsistencies between the network settings configured in FSP-5000-RPS and those set in
the panel controller are displayed under Diagnostics - Network services -
Consistency check.
1.
2.
3.
Problems of active configuration:
The table indicates inconsistencies between the network settings of the panel controller's
active configuration ("active") and the settings configured in RPS ("configured").
Problems expected after restart:
The table indicates inconsistencies between the network settings that have already been
configured on the panel but which do not take effect until restart ("saved") and the settings
configured in RPS ("configured").
13.7.3

Ethernet ports

To display a table listing the various parameters and the status of the two Ethernet ports:
1.
2.
3.
Bosch Sicherheitssysteme GmbH
Routing table
A table with routing information is displayed.
CAN 1 interface
CAN 2 interface
Ethernet 1 (IP multicast or UDP tunnel)
Ethernet 2 (IP multicast or UDP tunnel)
Ethernet 3 (IP multicast or UDP tunnel)
Ethernet 4 (IP multicast or UDP tunnel)
USB 1 interface
In the start menu, select Diagnostics
Network services
Consistency check
Where inconsistencies are identifiable between the network settings saved in the panel
controller and those configured in FSP-5000-RPS, these are indicated. You can use the
arrow key on the display to alternate between displaying Problems of active
configuration: and Problems expected after restart:.
In the start menu, select Diagnostics
Network services
Ethernet ports
Information on Ethernet port 1 is displayed.
You can use the arrow key on the display to switch to details of Ethernet port 2, port 3
and port 4.
To update the information displayed, select Refresh.
User Guide
Diagnostics | en 59
2020-07 | 3.0 | F.01U.378.877