Srx5600 Rack And Cabinet Requirements; Srx5600 Services Gateway Rack Size And Strength Requirements - Juniper SRX5600 Hardware Manual

SRX5600 Rack and Cabinet Requirements

IN THIS SECTION

SRX5600 Services Gateway Rack Size and Strength Requirements | 164

Spacing of Rack Mounting Bracket Holes for the SRX5600 Services Gateway | 165
Connection to Building Structure for the SRX5600 Services Gateway Rack | 165
SRX5600 Services Gateway Cabinet Size and Clearance Requirements | 165
SRX5600 Services Gateway Cabinet Airflow Requirements | 166
SRX5600 Services Gateway Rack Size and Strength Requirements
The size, strength, and location of the rack must accommodate the services gateway's weight and external
dimensions. The location of the rack must allow for the clearance requirements specified in .
The chassis is 17.37 in. (44.11 cm) wide. The services gateway is designed for installation in a standard
19-in. rack, as defined in Cabinets, Racks, Panels, and Associated Equipment (document number EIA-310-D)
published by the Electronics Industry Association (http://www.eia.org). The spacing of the holes between
the left and right front-mounting flanges and center-mounting brackets is 18.31 in (465 mm) apart. However,
the inside spacing between the rack rails must allow sufficient space for the width of the chassis.
With the use of adapters or approved wing devices to narrow the opening between the rails, the services
gateway can fit into a 600-mm-wide rack, as defined in the four-part Equipment Engineering (EE); European
telecommunications standard for equipment practice (document numbers ETS 300 119-1 through 119-4)
published by the European Telecommunications Standards Institute (http://www.etsi.org).
Observe these guidelines:
The rack must have sufficient vertical usable space to accomodate the height of the services gateway:
14.0 in. (35.6 cm) high (approximately 8 U). You can stack five services gateways in a rack that is at least
48 U (89.3 in. or 2.24 m) in height.
NOTE: A U is the standard rack unit defined in Cabinets, Racks, Panels, and Associated
Equipment.
164