Srx5600 Services Gateway Craft Interface Online Buttons - Juniper SRX5600 Hardware Manual

Table 9: Fan LEDs
Label Color
OK Green
FAIL Red

SRX5600 Services Gateway Craft Interface Online Buttons

The craft interface has a row of Online/Offline buttons along its lower edge. Each button corresponds to
one slot in the card cage. The Online/Offline buttons are only supported for slots containing MPC interface
cards. You can install MPCs into slots:
SRX5400–Any slot except bottom slot 0
SRX5600–Any slot except bottom slots 0 or 1
SRX5800–Any slot except center slots 0 or 1
NOTE: The Online/Offline buttons are not supported for removal and replacement of SPCs or
SCB.
CAUTION:
device is configured as part of a high availability (HA) cluster, we strongly recommend
that you do not push any of the Online/Offline buttons.
To take an MPC offline using the Online/Offline buttons:
1. Press and hold the corresponding card's Online/Offline button on slot 1 on the craft interface. The
green OK/FAIL LED next to the button begins to blink. Hold until both the button's LED and the MPC's
LED are off.
2. Issue the CLI show chassis fpc command to check the status of installed MPCs. As shown in the sample
output, the value Offline in the column labeled State indicates that the MPC in slot 1 is now offline:
user@host> show chassis fpc
State
On steadily
On steadily
While traffic is passing through the Services Gateway, particularly if the
Description
Fan tray is functioning normally.
Fan tray has failed.
38