Stern Bracket Assembly - BRP E250DHLSCS Service Manual

Evinrude e-tec series 250, 300 hp 90 v6 (3.4l)

Table of Contents

Remove the two trim rod rollers from the swivel

1. Trim rod roller

Remove the tilt support and bushing from the

swivel bracket and inspect the detent roller and

1. Tilt support bushing

Stern Bracket Assembly

components have been thoroughly cleaned.

Replace any seals that have been removed.

Inspect all thrust washers and bushings for evi-

dence of deterioration.

Install the detent roller and spring and the tilt sup-

port with bushing in the swivel bracket. Tighten

bushing to a torque of 28 to 30 ft. lbs. (38 to 41

1. Tilt support bushing

STERN BRACKET

Before proceeding, make sure all

Table of Contents