Framing Dimensions Corner Kit - Corner Install (Left Corner) - Regency City CB72EPV-LP Owners & Installation Manual

installation

Framing Dimensions Corner Kit - Corner Install (Left Corner)

NOTE: Framing may be constructed of combustible material (ie. 2 x 4)and does not require steel studs.
Framing
Description
Dimensions
A Framing Height
B Framing Width
C Framing Depth
D Unit Base to Top Enclosure (Min.)
G Vent Centerline Height
NOTE: Unit cannot be load-bearing. All finishing materials must be supported by the framing.
Note: This appliance must be in-
stalled on a level and solid surface
such as a plywood floor which must
be the full width and depth of the
appliance.
| City Series CB72EPV
36
Corner Kit
51" (1295mm)
84" (2134mm)
20-5/8" (524mm)
87"(2210mm)
55-1/4" (1403mm)
Maximum material di-
mensions 2" x 4" for
header studs (installed
on edge and flat)
Note: A combined minimum of
120 square inches of open area
is required for the convection air
outlet to cool the enclosure. En-
sure clearances for Convection Air
Outlets are met.
See clearances CB72EPV in this
manual as there are different meth-
ods as to how this can be achieved.