Framing Dimensions Corner Kit - Corner Install (Right Corner)
NOTE: Framing may be constructed of combustible material (ie. 2 x 4)and does not require steel studs.
Framing
Description
Dimensions
A
Framing Height
B
Framing Width
C
Framing Depth
D
Unit Base to Top Enclosure (Min.)
G
Vent Centerline Height
NOTE: Unit cannot be load-bearing. All finishing materials must be supported by the framing.
Note: This appliance must be in-
stalled on a level and solid surface
such as a plywood floor which must
be the full width and depth of the
appliance.
Corner Kit
51" (1295mm)
84" (2134mm)
20-5/8" (524mm)
87"(2210mm)
55-1/4" (1403mm)
Maximum material di-
mensions 2" x 4" for
header studs (installed
on edge and flat)
installation
Note: A combined minimum of
288 square inches of open area is
required for the convection air outlet
to cool the enclosure.
Ensure clearances for Convection
Air Outlets are met.
See clearances CB72EPV in this
manual as there are different meth-
ods as to how this can be achieved.
City Series CB72EPV |
35