Cb72Epv Glass Panel Installation - Regency City CB72EPV-LP Owners & Installation Manual

CB72EPV Glass Panel Installation

CB72E GLASS PANEL INSTALLATION
1. Turn off power and gas to unit and allow to cool to room temperature.
Remove the safety glass and fi rebox glass — see manual for instructions.
Note: The screws to secure all of the clips in these instructions will be already
on the appliance. Simply remove and reinstall to secure all of the clips.
2. Identify panels and order of installation.
13
9
12 1
14
7/8
15
3. Install back corner panels (1, 2) - seat smallest panel in back left corner,
repeat on other side.
4. Install inner base panel sets (3/4, 5/6, 7/8), metal panels fi rst, then glass
panels on top.
5. Inner panels (1-8) installed.
919-899
10
11
5/6
3/4
16
6. Install four back panel brackets in between the back wall and the burner tray.
Line up the center of the middle brackets with the base panels installed in
the previous step as shown below.
18
2
7. Carefully manoeuvre the back glass panels (9,10,11) to the back wall of
the fi rebox. Start with back panel 9 -- place two panel brackets on each
17
panel and manoeuvre into position, sliding the bottom into the corner and
back brackets.
8. Secure the top of the panel brackets with 2 screws into 2 brackets (each
panel has 2 brackets).
Secure 2 top brackets
9. Repeat Steps 7 & 8 to install back panels 10 + 11.
10. When completed, install fi rebox glass--see manual for detailed instructions.
1
installation
CITY SERIES
9
City Series CB72EPV |
08.14.18
87