Inner Glass Panel Installation / Removal - Regency City CB72EPV-LP Owners & Installation Manual

Inner Glass Panel (Firebox Glass) Installation / Removal
Note: glass panels must be installed to operate fireplace
WARNING: GLASS HANDLING
We recommend using the glass vacuum holders supplied by the manufac-
turer. Lower the glass to rest in a safe place, this is to prevent damage to the
glass edges. Extra care must be taken when removing/installing the glass.
Breakage or damage to the edge of the glass which occurs as a result of
careless handling will not be covered under warranty.
• W e recommend handling the glass with supplied vacuum
clamps
• When removing glass–prepare a soft, scratch resistant
surface to place the 70-3/8"x 15-1/4" glass
• Never clean or remove hot glass
Note: The suction cups may leave a round film on the glass
when used. Ensure that the glass is cleaned using a fireplace
glass cleaner after each removal and prior to operating the
appliance.
1. R emove outer safety barrier glass panels if previously installed–see instruc-
tions in this manual.
2. R emove outer panels installed in unit - see panel removal section in this manual.
Press glass vacuum clamps in open position firmly onto surface of glass.
Bring handles together to close.
Open
Handle glass with supplied vacuum clamps
Note--the following installation diagrams do not include the
vacuum clamps but it is strongly recommended to use
clamps at all times when handling the firebox glass.
Closed
Glass removal video
3. F rom the front inside lower panel of the unit--pivot the 3 glass supports into
upright position as shown below.
Glass supports in upright position
4. O pen the 8 clamps at the top of the glass.
Top clamps in open position
Clamps in closed position
installation
glass supports
Clamps in open position
City Series CB72EPV | 75