Cb72Epv Enamel Panel Installation - Regency City CB72EPV-LP Owners & Installation Manual

CB72EPV Enamel Panel Installation

CB72E ENAMEL PANEL INSTALLATION
Black Enamel Panels — Handling Instructions
•
Black Enamel panels must be inspected for scratches and dimples prior to installation.
All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
•
Black Enamel panels will discolor a little during normal operation. This is normal and should not be considered a defect.
*
All hand and fi nger marks MUST be cleaned off with a soft cloth. Use an ammonia based cleaner (ie. glass cleaner) to remove any fi ngerprints before
applying heat to the unit.
Failure to do this will result in burn stain on panels which you will be unable to remove.
*Not protected by product warranty.
The CB72E has optional enamel inner panels that may be installed.
CV72E - 7 outer panels and 8 inner panels.
Turn off power and gas to unit and allow to cool to room temperature. Remove
the safety glass and fi rebox glass — see manual for instructions
1. Install 5 inner base panels as shown.
2. On back of fi rebox wall--install 6 screws (loosely) in locations shown
below. Install 3 back panels--hang panels on installed screws through
keyhole opening.
3. Reinstall fi rebox glass - see instructions in manual.
919-898
CB72E OUTER PANELS
1. Install outer side panel as shown below.
2. Install glass stopper (if desired) by sliding down the outside of the
outer side panel.
1
installation
CITY SERIES
08.14.18
City Series CB72EPV | 85