Glass Barrier Installation - Front; Glass - Regency City CB72EPV-LP Owners & Installation Manual

installation

Glass Barrier Installation - Front

OWNERS/INSTALLATION MANUAL
Glass barrier installation
1. Ensure fireplace is operating properly and all firebox glass, and liner panels are installed prior to
installing the glass safety barrier.
2. Remove the protective peel from the glass safety barrier and clean the inner surface. Identify the
hooks on the glass safety barrier, these indicate the inner surface.
3. Attach the vaccum clamps to the glass as shown on the outer surface. Press the vacuum clamps
against the glass, then close the clamps while maintaining pressure on the glass.
4. Slide the corner protectors onto the bottom corners of the glass.
Vacuum clamps
Open
Closed
5. Holding the glass barrier in front of the unit, slide it up behind the top lip of the unit. Lift the barrier
up as far as it goes, then hook the barrier onto the unit.
Slide behind top lip
6. Visually inspect that the lower hooks are sitting over their pins
and that the glass is sitting level and centered in the opening.
7. Remove vacuum clamps and corner protectors.
8. To remove glass, see owner's manual.
102 | City Series CB72EPV
Corner
protector
Lift up
Glass barrier removal video
Vacuum
clamps
Push forward
Corner
protector
Lower onto hooks