Front & Side Glass Barrier Removal - Regency City CB72EPV-LP Owners & Installation Manual

Front & Side Glass Barrier Removal
Note: O nly the front glass barrier is shown in diagrams - follow same
OWNERS MANUAL
procedure for side glass barrier removal.
Glass safety barrier removal
1. Prepare a soft, scratch resistant surface to place the 70-3/8 " x 15-1/4" glass (i.e. large sheet or clean
drop cloth).
2. Attach the vacuum clamps to the glass as shown. Press the vacuum clamps against the glass, then
close the clamps while maintaining pressure on the glass.
3. Slide the corner protectors onto the bottom corners of the glass. If you don't have these, place a soft
cloth or piece of cardboard under the glass barrier to protect the corners during removal.
Vacuum clamps
Open
4. Using the vacuum clamps, lift the barrier straight up, pull it toward you, then gently lower it straight
down (see below).
Lift
5. Angle the bottom edge toward you and carefully lift the glass barrier out, placing it on your
prepared soft, scratch resistant surface (i.e. drop cloth).
6. To reinstall, reverse steps.
Corner
protector
Closed
Pull forward
Glass barrier removal video
Vacuum
clamps
Lower down
owner's information
Corner
protector
Angle out
City Series CB72EPV | 17