Erasing Center And Edge Margins - Ricoh Priport JP5800 Operating Instructions Manual

Ruby-gb3_FM.book Page 50 Tuesday, January 25, 2000 3:03 PM
Operation

Erasing Center and Edge Margins

When printing from thick books, or
similar originals, the binding margin
1
at the center and the edges might ap-
pear on prints. To prevent this, per-
form the following steps.
Important
Be sure to keep the platen cover at
an angle of at least 25 degrees with
the exposure glass.
If you do not press hard on the
book while it is scanned, the mar-
gin at the center might no be
erased completely.
Note
If your originals have solid images
at the edges, the machine might
recognize the solid images as shad-
ows and not copy them. In this
case, use Edge Erase mode so that
only the shadows are not copied.
See ⇒ P.51 "Edge Erase—Erasing
Edge Margins"
A
Set the book on the exposure
glass.
50
B
Keep the platen cover at an angle
of at least 25 degrees with the ex-
posure glass.
C
Press the {Start} key.
Note
Press hard on the book with
your hand while it is scanned.
D
Check the image position of the
trial or proof print.
Note
If the image position is not cor-
rect, adjust it using the [Image
=] key (see ⇒ P.34 "Adjusting
the Position of Printed Images").
E
Make your prints.