Skip Feed Printing - Ricoh Priport JP5800 Operating Instructions Manual

Ruby-gb3_FM.book Page 78 Tuesday, January 25, 2000 3:03 PM
Operation

Skip Feed Printing

If the backs of prints are dirty, you
can increase the time between prints
1
using the {Skip Feed} key. By default,
when one sheet of paper is fed the
drum rotates once. However, you can
select the number of rotations of the
drum. This gives you the chance to re-
move prints one by one from the pa-
per delivery tray or insert one sheet of
paper between two prints. If you use
this function, you can also use paper
longer than 432mm, 17.0" in spite of
the maximum length limitations of
paper.
Note
Two rotations while one sheet of
paper is fed is selected as a default.
You can change this default setting
with the user tools. See "No. of
Skip Feed" ⇒ P.152 "4. Mode Set-
ting".
The maximum length of paper in
Skip Feed mode is 460mm, 18.1".
When you use paper longer than
432mm, 17.0", completed prints
will not be delivered to the paper
delivery tray properly, so lower
the paper delivery end plate and
receive completed prints by hand.
A
Set your original on the exposure
glass (contact glass) or in the op-
tional document feeder.
78
B
Press the {Skip Feed} key.
C
If necessary, select the number of
rotations of the drum while one
sheet of paper is fed with the [←]
[→] or {~} {}} keys.
Note
You can also select the number
of rotations with the Number
keys.
You can select from 2 to 9 rota-
tions.
By default, the machine asks
you to confirm the number of
rotations. You can have this step
omitted by adjusting the user
tool settings. See "No. of Skip
Feed" ⇒ P.152 "4. Mode Set-
ting".
D
Press the [OK] key.