Ricoh Priport JP5800 Operating Instructions Manual page 201

Ruby-gb3_FM.book Page 181 Tuesday, January 25, 2000 3:03 PM
Message
Cannot sort irregular
sized papers.
Non-sort tray is not
set correctly
Sorter is full.
Please remove the pa-
per
Papers are left on the
sort tray.
Please remove.
Switch on the sorter
Or communication
error.
-When a service call message is shown on the panel display panel
Press the [Exit] key. Then turn the main switch off and back on again. If a service
code appears again, contact your service representative.
Note
If a service code appears on the panel display after you turn the main switch
off and on a few times, do not continue turning it on and off. Leave the ma-
chine off.
When you make masters continuously using originals with solid images,
"SC-03-03" tends to appear on the panel display. In this case, turn off the main
switch and wait for a while. Then turn on the main switch.
Meaning
The custom size is selected.
Press the [Exit] key to dismiss the message and use paper other
than the custom size.
If you cannot change the paper type, press the [Exit] key to dis-
miss the message and disable sorter mode.
Note
If you press the [Exit] key the message will be dismissed but
it will be displayed again when making the master or
prints.
Slide in the delivery tray of the sorter correctly.
The number of prints exceeds the capacity of the bin. Remove
the paper from the sorter.
Remove the paper from the sorter tray.
If the sorter power plug is pulled out, plug it in and turn it on.
If the message appears again, there was an error connecting to
the sorter.
Contact your local representative.
If Your Machine does not Operate as You Want
5
181