11. MR-D01 EXTENSION I/O UNIT
11.5.3 Signal (device) explanations
This section describes the signals (devices) of the MR-D01 extension I/O unit.
The connector pin No. column in the table lists the pin Nos. which devices are assigned to by default.
For the I/O interfaces (symbols in the I/O division column in the table), refer to section 11.5.4 (2). The
symbols in the control mode field of the table shows the followings.
CP: Positioning mode (point table method)
BCD: Positioning mode (point table method in the BCD input positioning operation)
CL: Positioning mode (program method)
PS: Positioning mode (indexer method)
" " and " " of the table shows the followings.
: Usable device by default.
: Usable device by setting the following parameters.
[Pr. Po02] to [Pr. Po09], [Pr. Po27], and [Pr. Po28]
11 - 42
www.kavrammuhendislik.com.tr