Table of Contents
Advertisement
Making the system redundant
4
Print the customer data block(s) in LD 21.
LD 21
REQ
TYPE
CUST
****
Core 1 is now active, clock 1 is active, FIJI Rings are half/
half, CNI is disabled in Core 0.
At this point, Core/Net 0 is ready to be synchronized with Core/Net 1.
Procedure 24
Making the system redundant
1
Attach the LAN 1 cable to the CP PIV faceplate connector on Core 0.
2
Enable all CNI cards in Core 0.
3
From Core 1 (the active Core), enter LD 135 and issue the JOIN
command. The high speed pipe (HSP) status is now up. This begins the
synchronization of the Call Servers.
LD 135
JOIN
CS 1000M SG CP PIV to CS 1000M MG CP PIV FNF Upgrade
Performing the upgrade
Load program
PRT
CDB
xx
Exit program
End of Procedure
Load program
Join the 2 CPUs together to become redundant
Page 94 of 159
Advertisement
Table of Contents
