Table of Contents
Advertisement
3
Perform a KDIF in LD 143.
4
Press the manual RESET button the Call Processor 1 (inactive) card
faceplate.
5
Call up the Software Installation Program during a SYSLOAD. During
SYSLOAD, the following prompt appears:
Read boot parameters from:
F: Faceplate compact flash
H: Hard Drive
0 [H]
Press F to boot from the compact flash (which contains the software).
For the CP PIV upgrade, the F must be in uppercase.
6
Enter <CR> at the Install Tool Menu.
Note: Blank CF prompts begin here.
Mounting /cf2
Found /cf2/nvram.sys
Mounting /boot|
Found /boot/nvram.sys
sources
Read boot parameters from:
F: Faceplate compact flash
H: Hard Drive
10 [F]
Press <CR> when ready
Reading boot parameters from /boot/nvram.sys
Press any key to stop auto-boot...
CS 1000M SG CP PIV to CS 1000M MG CP PIV FNF Upgrade
Performing the upgrade
Selecting nvram file from 2
Page 78 of 159
Advertisement
Table of Contents
