Page 133 of 159
Connecting a Dell COTS server
Figure 29
Dell R300 server (rear view)
NN43021-466
Standard 06.02
lnstalling a Signaling Server
In geographic regions that are susceptible to electrical storms, Avaya
recommends that you plug the Dell server into an AC surge suppressor.
Figure 29 shows the rear view of the Dell R300 server.
Note: When you perform Procedure 33, "Connecting a Dell COTS
server," on
page
Procedure 33
Connecting a Dell COTS server
1
Connect the Dell server to the TLAN subnet. Insert the RJ-45 CAT5 (or
better) cable into the TLAN Ethernet port on the back of the server. Insert
the other end of the cable into the TLAN subnet of the Layer 2 switch.
2
Connect the Dell server to the ELAN subnet. Insert the RJ-45 CAT5 (or
better) cable into the ELAN Ethernet port on the back of the server. Insert
the other end of the cable into the ELAN subnet of the Layer 2 switch.
3
Connect a DTE–DTE null modem serial cable from the Serial Port on the
back of the server to a maintenance terminal.
4
Connect the Dell server power cord.
December 2013
133, see Figure 29.