Table of Contents
Advertisement
5-8. Method for adjusting the workpiece stopper
1
5-9. start switch
cAutIon
:
When you press the start switch, the garment-body presser comes down. At the same
time, the loop clamp moves toward the sewing machine at a high speed. take added care
to keep your hands away from the loop clamp during work.
1
1
2
1
3
2
3
– 26 –
Loosen screws 1 and adjust the poston of the
workpece stopper accordng to the belt loop at-
tachng locaton on the garment body.
In the case the workpiece stopper is
adjusted to a position which is behind
the needle entry point by 17 mm or
more, the risk of catching the garment
body between the throat plate and the
workpiece stopper can be posed. In
the case the workpiece stopper posi-
tion has to be adjusted to 17 mm or
more away from the needle entry to-
ward far side, the custom-made mate-
rial stopper should be used to avoid
the problem.
Once you have completed preparaton for sewng,
you can brng the sewng machne nto operaton
by pressng start swtch 1 .
When the loop clamp 2 has clamped the belt
loop, operaton of the start swtch 1 wll be ac-
cepted.
1. operate the sewing machine taking
care not to allow your hands move
above safety cover 3 since the
hands can interfere with the loop
clamp.
2. If you do not keep the start switch
held pressed for a sufficiently long
time, sewing will be interrupted. Be
sure to keep the start switch fully
held pressed.
3. You may also press the start switch
while the belt loop clamp clamps
the belt loop and travels to the
standby position after the comple-
tion of sewing. In that case, the
belt-loop clamp will not stop at
the standby position but will move
directly to the sewing position to
start the next sewing. Be sure to
exercise added care during this
procedure.
Advertisement
Table of Contents
