How To Change The Thread Tension Command From Needle Entry Point To Needle Entry Point; How To Add/Change The Thread TensOn Command From Needle Entry PoNt To Needle Entry PoNt - JUKI AB-1351 Instruction Manual

2-22. How to change the thread tension command from needle entry point to needle entry point

(1) How to add/change the thread tension command from needle entry point to needle entry point
A
I
C
E
1 Displaying the thread tension command change screen
Press thread tenson button
when you select a user pattern to dsplay the thread tenson
settng screen. When you press thread command change but-
ton B on the thread tenson settng screen, the thread
tenson command change screen s dsplayed.
If the start swtch s pressed, the work clamp foot wll be low-
ered.
In this mode, the sewing machine will not start even if
you press the start switch.
B
2 specifying the location of the command to be changed
Specfy the locaton to whch a new thread tenson command
you want to add, or at whch the current thread tenson com-
mand value you want to change by means of 1-sttch back-
ward button
the work clamp foot lowered.
You can also move the needle entry pont to another one, be-
D
fore or after the current pont, at whch a thread tenson com-
H
mand value s set by means of
G
F
movng the needle entry pont, press stop button
When you press return-to-orgn button
closed and dsplays the LK unt sewng screen.
The values shown on the screen are absolute values (thread
tenson value + Thread tenson command value).
– 68 –
A on the sewng screen
C or 1-sttch forward button
E or
D wth
F . To stop
G .
H , the screen s