Table of Contents
Advertisement
2-33. trial stitching function
Data created wth PM-1 (sewng data programmng/edtng software) can be used for tral sttchng
by connectng the personal computer and the sewng machne onlne.
Connect the personal computer wth the IP-420. Create data wth the PM-1. Then, transmt the data
to the sewng machne. When the IP-420 dsplays the data entry screen, the tral sttchng screen s
automatcally dsplayed. Refer the HELP for the PM-1 for how to operate the PM-1.
When programming a pattern, the starting point has to be set at coordinates (0, 0) or
enter a second origin at coordinates (0, 0). Be aware that the garment-body presser
and the wiper can interfere with each other depending on the location of the sewing
starting position.
● How to carry out trial stitching
A
B
Data transmsson
PM-1
1 receiving trial stitching data from the PM-1
When the data on tral sttchng (vector form data) s sent from
the PM-1, the tral sttchng screen shown at left s dsplayed.
At the center of the screen, the needle entry dagram of the
transmtted data s dsplayed. The needle entry dagram dffers
n color accordng to the thread tenson value.
2 Editing the vector data
C
Three tems show descrbed below can be set for the vector-
form data transmtted from the PM-1.
A : Thread tenson
B : X actual-dmenson value
C : Y actual-dmenson value
3 changing the data
When you press tem ( A - C ) button you want to change, the
numerc keys are dsplayed. Enter a desred value.
After the data entry, press enter button
D
IP-420
– 107 –
D .
Advertisement
Table of Contents
