Table of Contents
Advertisement
3-10. Installing the belt loop feeding unit (optional)
1
A
2
3
4
5
6
In the case the belt loop feeding unit
is to be installed on the machine, the
belt loop guide parts installed as stan-
dard at the time of delivery have to be
removed.
Mount the belt loop feedng unt on the table and
fix it by tightening screws 1 on the undersde of
the table.
Connect exclusve juncton cable 2 to the juncton
board located behnd the man body.
Connect juncton cable 2 to connector 3 on the
feedng unt sde.
Pull out plug 5 from ar couplng 4 . Then, con-
nect ar tube 6 on the belt loop feedng unt sde
to ar couplng 4 .
Change the settng to "wth belt loop feedng auxl-
ary unt" on the machne settng N806 A .
→ Refer to
"@-2-29. How to set the device"
– 14 –
,
p.98.
Advertisement
Table of Contents
