Table of Contents
Advertisement
(2) Memory switch data list
no.
Multi-layered part detecting function enabled/disabled
Enable/dsable of the mult-layered part detectng functon s selected
wth ths swtch.
Enable
Multi-layered part cutting position (front)
In the case, when the top of seam (.e, jont) of a belt
loop s detected, the part of the belt-loop before the
detected seam s to be cut as a defectve part, the
length of the part of the belt-loop to be cut s entered
wth ths swtch (n mm). Snce the area around the
seam s lkely to bulge gradually toward the seam,
accuracy of the seam detecton vares accordng
to the belt-loop materal. Ths swtch s provded to
compensate the detecton accuracy.
In addton, ths swtch sometmes has to be adjusted
accordng to the belt-loop wdth.
* The front-sde trmmng of the mult-layered part s
only enabled when the front/rear s selected for the
mult-layered part trmmng poston. (memory swtch
level 2 K551).
Refer to the Engneer's Manual for the memory
swtch level 2. In the ntal state, the front part of the
belt-loop s not cut.
seam cutting position (rear)
The length of a belt-loop from the rear end of a
seam to the belt-loop cuttng poston s set wth ths
parameter (n mm).
Snce the area around the seam s lkely to bulge
gradually toward the seam, accuracy of the seam
detecton vares accordng to the belt-loop materal.
Adjust ths parameter to around 10 to adjust the
aforementoned length to approxmately 10 mm
accordng to the belt-loop materal. If ths length has
no allowance, the seam may reman on the belt loop.
Belt-loop multi-layered part detection display
initial value
Ths swtch s used to set the ntal value to
determne the mult-layered part of a belt loop for the
newly created belt loop pattern.
→ Refer to
p.53
for detals.
Belt-loop no-insertion detection display
initial value
Ths swtch s used to set the ntal value to
determne no-belt-loop state for the newly created
belt loop pattern.
→ Refer to
p.53
for detals.
Item
Dsable
"@-2-13. Belt loop teaching function",
"@-2-13. Belt loop teaching function",
– 94 –
Input range/
Initial
selection range
value
―
Enable
0 to 99
10
(mm)
(mm)
0 to 99
10
(mm)
(mm)
0 to 255
70
0 to 255
0
Advertisement
Table of Contents
