JUKI AB-1351 Instruction Manual page 123

Error
Display
code
clamp lower-position sensor
E387
fault (lower position)
The lower poston sensor s
n the OFF state or the upper
poston sensor s n the ON state
when the clamp rests at ts lower
poston.
→ Ths error also occurs n the
case the clamp fals to come
down to the sensor nput poston
when a heavy-weght sewng
materal s used.
clamp position sensor fault
E388
(upper and lower positions)
The clamp poston sensor nput s
wrong at both the upper and lower
postons.
copy is disabled
E401
Erase is disabled (in use for
E402
cycle operation)
creation of new data is disabled
E403
Pattern number selection is
E404
disabled
E435 out of input range error
sub-PWB backup data
E476
conversion
Belt-loop loosening motor out
E477
of range
Ths error code s dsplayed n
the case the total of belt-loop
dmensons B and D exceeds
66.0 mm for shape Nos. 4 and 5,
n the case the total of belt-loop
dmenson B and a half of the
loosenng amount exceeds 66.0
mm for shape Nos. 7 and 12, or
n the case the total of belt-loop
dmenson B and the loosenng
amount exceeds 66.0 mm for
shape Nos. 9 and 11. Respectvely
set the aforementoned
dmensons so that the total value
does not exceed 66.0 mm.
Description of error
– 118 –
Display message
How to Place of
recover recovery
Re-start Data
after nput
resettng s screen
enabled.
Re-start Data
after nput
resettng s screen
enabled.
Possble Prevous
to re-enter screen
after reset.
Possble Prevous
to re-enter screen
after reset.
Possble Prevous
to re-enter screen
after reset.
Possble Prevous
to re-enter screen
after reset.
Possble Prevous
to re-enter screen
after reset.
Turn OFF
the power
Re-start Prevous
after screen
resettng s
enabled.