Function Of Canceling Grasping Of A Belt Loop For The Next Sewing - JUKI AB-1351 Instruction Manual

Hide thumbs Also See for AB-1351:
Table of Contents

Advertisement

2-15. Function of canceling grasping of a belt loop for the next sewing

Ths functon s used to prohbt the setback operaton after the end of sewng. In the case you know that
the power to the machne wll be turned off after the end of sewng, or n the case you don't need to set-
back the next belt so as to change over the product, ths functon s used to prevent the next belt loop
from beng grasped uselessly.
A
When press button
state (ON state)
end of sewing. When one sequence of belt-loop sewing is finished
n the ON state, the button s reset (OFF state).
In addition to the end of sewing as described above,
the cancellation of grasping of a belt loop for the next
sewing (prevention of the setback operation after the
end of sewing) can be reset from the state where but-
ton A is pressed in the following cases:
When the button, which is in the on state, is
pressed again (to place it in the oFF state)
When the ready key is pressed on the sewing
screen (green) to return to the data entry screen
(blue);
When the power is turned oFF;
When the error screen is displayed;
When you carry out sewing using the step operation
function (the screen changes to the step operation
selection screen).
– 58 –
A , the button s brought to the depressed
to prohbt the setback operaton after the

Advertisement

Table of Contents
loading

Table of Contents