Step 4 : Attach The Cutting Tool - Roland monoFab SRM-20 User Manual

〇〇〇●

STEP 4 : Attach the Cutting Tool

Select a cutting tool matched to the purpose.
If you use the tools selectively according to the work process such as
"Roughing" or "Finishing"
finish. Use a collet that fits the diameter of the cutting tool that will be used.
""Cutting Tools"
(p. 19)
CAUTION
Do not touch the tip of the cutting tool with your fingers.
Doing so may result in injury.
Procedure
1.
Insert a cutting tool in a collet.
Do not insert to the portion of an edge. When you use included cutting tool,
refer to the following figure.
and the design, you can obtain an even cleaner
10mm
Aim of the cutting tool installation
84
Preparing the Machine
OK
NG
NG