Table of Contents
Advertisement
Tool-Diameter Offset (G41, G42)
The ranges of the G41 and G42 parameters are as follows .
Parameter : Number
Function : Offset number
Acceptable range : 0 to 8
Valid range : 0 to 8
Feed Rate (F)
The range of the F parameter is as follows .
Parameter : Feed rate
Function : Feed rate
Acceptable range : Range 1
Valid range:
X and Y axes : 6 - 1800 mm/min (0 .24 - 70 .87 inch/min)
Z axis : 6 - 1800 mm/min (0 .24 - 70 .87 inch/min)
Interpretations of NC Code Omissions
When NC codes are omitted, the machine performs the following interpretations . The machine performs interpretations when NC codes are omitted in a
characteristic manner . If you want to write general-purpose programs, do not omit NC codes .
"NC Code Reference Manual"
" Separate volume
Unit Setting (G20, G21)
If these codes are omitted, the machine assumes millimeter input (G21) at all times .
Tool-Diameter Offset (G41, G42)
If these codes are omitted, the value that was set on the
VPanel, is used .
[Tool-diameter Offset]
tab, which is accessed by clicking
113
NC Code Specifications
[Setup]
and then
[NC Code setting]
on the
Advertisement
Table of Contents
