Roland monoFab SRM-20 User Manual page 86

When changing to a cutting tool with the same shank diameter
CAUTION
Do not touch the tip of the cutting tool with your fingers.
Doing so may result in injury.
Procedure
1.
Loosen the set screw with hexagonal wrench.
Support lightly by hand not to drop a cutting tool.
2.
Remove the cutting tool.
3.
Attach the cutting tool which you want to use ,and tighten the set
screw.
When changing to a cutting tool with a different shank diameter
Procedure
1.
Remove the collet from machine.
Refer to the procedure 4 to 5 of
in revers order, remove the collet.
2.
Attach the cutting tool.
Refer to the procedure of
attach the cutting tool.
86
Preparing the Machine
"STEP 4 : Attach the Cutting Tool"
"STEP 4 : Attach the Cutting Tool"
(p. 84)
(p. 84),