Step 3: Performing Cutting; Player 4); Step 3: Performing Cutting (When You Are Using Modela Player 4) - Roland monoFab SRM-20 User Manual

〇〇●〇〇

STEP 3: Performing Cutting (when you are using MODELA Player 4)

MEMO
If you are using SRP Player rather than MODELA Player 4, proceed to
3: Performing Cutting (when you are using SRP Player)."
"STEP 3: Performing Cutting (when you are using SRP Player)"
"
MEMO
During cutting, you can adjust the cutting tool movement speed or the
spindle speed.
You can also pause/resume or cancel the cutting.
""Pausing / Resuming"
(p. 104)
""Cancel the Cutting"
(p. 105)
"Caution of Cutting After an Emergency Stop and a Shutdown"
"
""Adjusting the Feed Rate and Spindle Speed During Cutting"
When "Cutting Position Setup"is displayed
If you have not performed a cutting preview in Virtual MODELA,
"Cutting-position Setup" is displayed. Then Click "OK."
The points to be checked before cutting
Check the following thing before starting cutting. If there are problems with
any of these, the cutting material may be wasted or the machine may be
damaged.
"STEP
(p. 93) □ Is an output file right?
□
Have you made a mistake with the origin point position?
□ Do the cutting conditions match the type of cutting material?
Procedure
1.
Click
(p. 105)
(p. 106)
100
Cutting (One Side Cutting)
[Cutting] of MODELA Player 4.