Roland monoFab SRM-20 User Manual page 96

4.
Select the surface of the material and then click
IMPORTANT
Before starting the cutting processes, double-check that the origin point
exists on the top surface of the material.
If the origin point is incorrectly positioned, the machine may fail to cut the
workpiece as expected or break down.
Origin point of the Model / Origin point
•
Origin point of the model : XY origin point set up on cutting data
•
Origin point : XY origin point set up on the machine
(Can be set anywhere in the cutting area)
(The origin point on the data of SRP Player)
Relation between the origin point of the model and the origin point
.
Set up the origin point of the model and the origin point of the machine to
become the same position.
Origin point : Center
Origin point of the model
: Center
Origin point : Lower left
Origin point of the model
: Center
96
Cutting (One Side Cutting)
OK OK
NG NG