Roland monoFab SRM-20 User Manual page 145

Message
The spindle rotation is stopped .
- The spindle motor experienced an overcurrent .
- The spindle motor experienced an excessive load or it is not
mounted .
The SRM-20 has performed an emergency stop .
- The X-Motor experienced an overload .
- The Y-Motor experienced an overload .
- The Z-Motor experienced an overload .
"File name"
was not found .
Responding
Turn off power of the machine .
The cutting may have exceeded the capacity of the
machine . Before restarting, revise the cutting conditions .
It is likely that it is time to replace the spindle unit or spindle
motor, so check these parts .
Turn off power of the machine .
The cutting may have exceeded the capacity of the
machine . Before restarting, revise the cutting conditions .
If cutting waste has built up and an excess load is being
applied to the axis, please clean up the cutting waste .
Delete the file that produced the error and select the file
again .
145
Responding to Error Messages
Page
""The Spindle Doesn't Rotate
/ Spindle Rotation Speed Is
Wrong" (p . 128)
""Replacement of the
Consumable Parts" (p . 122)
"Cleaning the X-/Z-Shafts"
"
""Cut Dialog"
(p . 17)
(p . 119)