Table of Contents
Advertisement
The Spindle Doesn't Rotate / Spindle Rotation Speed Is Wrong
Is a Front Cover Open?
When starting the machine, close the front cover . For safety, initialization is
not performed when a cover remains open at startup .
Is a Front Guard Pull Down ?
When the front guard falls down, the front cover can not be closed firmly .
Therefore the machine is not performed .
""Part Names and Functions"
Is a Large Amount of Cutting Waste Present?
Clean away any cutting waste . Clean the area around the spindle head
especially carefully .
""Cleaning after Cutting Operation Ends"
Is It the Replacement Time of a Spindle Motor?
Spindle motor is consumable . If it is used for 500 hours or more, replace for
a new spindle motor .
""Replacement of the Consumable Parts"
(p . 9)
(p . 119)
(p . 122)
Is It the Replacement Time of a Spindle Unit?
Spindle unit is consumable . If it is used for 1000 hours or more, replace for a
new spindle unit .
""Replacement of the Consumable Parts"
Even if it replaces spindle motor/unit, when not being repaired
Contact your authorized Roland DG Corporation dealer where you purchase
the machine .
Has the Spindle Speed been Adjusted (Override )?
An adjusting rotation of spindle changes the rotation speed .
Unless you have a special reason for changing them, leave all overrides set
at
"High."
The Feed Rate is Wrong
Has the Feed Rate been Adjusted (Override ) ?
An override changes the feed rate . Check the settings for adjustment value .
Unless you have a special reason for changing them, leave override set at
100% .
""Adjusting the Feed Rate and Spindle Speed During Cutting"
106)
128
What to Do If . . .
(p . 122)
(p .
Advertisement
Table of Contents
